Academy Overhead Line Equipment (OLE) and Third Rail Electrification
Prototype & Railfanning
Overhead Line Equipment (OLE) and Third Rail Electrification
The Contact Wire: The copper rail that actually touches the pantograph head. It is not hung perfectly parallel to the tracks; it zig-zags from left to right across the track centerline (usually by about 200–300mm per mast). This spreads wear evenly across the graphite strip of the pantograph, preventing a single groove from sawing it in half.
The Catenary Wire: The top support wire that hangs in a natural curve between structures. Vertical drop dropper wires hang from it at variable lengths to keep the contact wire below completely flat.
Tensioning Weights: Huge concrete or steel weights hang from pulleys on specific anchor masts. They pull the wires tight to keep them from sagging when hot summer temperatures expand the copper metal.
[ Anchor Mast ] ---- (Catenary Wire) --- /--- | ---(Dropper)-/ | ================================================== <- Contact Wire (Flat) | /
[Weights] / <- Zig-Zags Left/Right
| /
2. Conductor Rail (Third Rail) Topography
Predominant on commuter networks like the southern regions of the UK, the third rail system uses a solid steel bar placed outside the running rails.
Voltage & Pick-up: Typically runs at 750V DC. The train collects this via a spring-loaded metal collector shoe sticking out from the side of its bogie (wheel assembly).
Gaps and Isolation: At junctions and level crossings, the third rail must break apart to clear path space. If a train is shorter than the gap, it can lose power completely—a state known as being "gapped". Modern multiple units feature internal electrical bus lines connecting shoes across different coaches to stop this happening.
Finished with this guide?
Join LopoRail to mark lessons complete and track your progress.