Academy Turnout Tuning and Frog Polarity
Model Railway Construction
Turnout Tuning and Frog Polarity
Insulfrog (Insulated Frog): The core point of the frog is made from solid plastic. It requires no complex wiring, but it leaves a dead electrical dead spot. Small or short-wheelbase locomotives (like 0-6-0 shunting engines) can get stuck on it if their power-collecting wheels land entirely on the plastic section.
Electrofrog (Live Frog): The entire crossing frog is milled from solid metal, ensuring continuous power delivery. However, because the rails converge, the frog's electrical polarity must change dynamically depending on which way the point blades are thrown. Leaving it unswitched causes an instant short circuit.
[ Insulfrog ] ======= (Metal) =======__ [PLASTIC FROG] __/======= [ Electrofrog ] ======= (Metal) =======__ [METAL FROG] __/=======
|
+---> Connected to external switch
to invert polarity (+ / -)
2. Wiring a live frog switch
To wire an Electrofrog turnout correctly, you must isolate the frog from the rest of your track layout:
Isolating Joins: Place two plastic insulating fishplates (joiners) on the two internal rails coming out from the V-end of the metal frog.
The Polarity Switch: Connect a dedicated dropper wire to the base of the metal frog. Feed this wire down through your baseboard and attach it to the internal microswitch on your turnout motor (such as a Seep or Tortoise motor).
Bus Feeds: Connect the input terminals of that same microswitch straight to your positive and negative main DCC track power bus lines. When the motor moves the physical track blades, it simultaneously snaps the electrical switch, matching the frog's polarity to the chosen route.
Finished with this guide?
Join LopoRail to mark lessons complete and track your progress.