Academy Layout Automation with Reed Switches and Block Detection
Model Railway Construction
Layout Automation with Reed Switches and Block Detection
The Switch: A reed switch is a tiny glass capsule containing two flat, magnetic metal contacts. You mount the capsule flush between the sleepers on your track layout.
The Trigger: You glue a tiny, powerful neodymium magnet onto the underside of your locomotive's bogie or trailing wagon chassis.
The Action: As the train rolls directly over the glass capsule, the magnet pulls the metal contacts together, closing the circuit. This instantly sends a pulse to control station modules, activating hidden relays to throw points, switch signal aspects, or trigger automated platform announcements.
2. Electronic Block Occupancy Detection
While reed switches track individual passing points, Current-Sensing Block Detection monitors an entire section of track continuously.
[ DCC Power Bus (+) ] ➔➔ [ Current Sensing Transformer Detector ] ➔➔ [ Isolated Track Block Section ]
|
+--- (Loco draws power = Tells computer block is Full)
How it Works: You isolate a specific track section by cutting gaps into one of the rails. You then route the DCC power feed to that isolated section through a current-sensing transformer board.
Detection Physics: The moment a locomotive or a wagon fitted with resistive wheelsets enters that isolated section, it completes the circuit and draws current from the track. The sensor board detects this power draw and signals your layout control computer (or DCC command station) that the section is occupied. This feedback system keeps trains separated and forms the backbone of fully automated computer control layouts.
Finished with this guide?
Join LopoRail to mark lessons complete and track your progress.